How to connect fan regulator in home switchboard?

Hi there,

Get Free Estimate

One of the questions we think about when we purchase a fan is: ' how to connect regulator to fan'. Well, to connect a fan you need to wire it. This process can be tricky so if you are an amateur it's better not to deal with this kind of electrical work. Before sharing the process of how to connect fan regulator to switch, I would like to provide this disclaimer.

How to wire fan regulator direct connection?

1. The phase circuit breaker is one side of the Miniature Circuit Breaker (MCB), and the neutral is one side.

2. You need to connect the neutral end of the phase circuit breaker to switch located in the switchboard and connect the phase breaker with the ceiling fan.

3. The ceiling fan should be connected with the regulator and the regulator with the ceiling fan.

4. Now, you need to check by turning the fan on and controlling the fan speed by turning the knob of the regulator. 

5. Take appropriate screws and connect the regulator to the switchboard.

6. Now place the switchboard cover plate on the wall.

Here you go. This is the easy process on how to connect regulator to fan. But again I will advise you to hire an electrician if you don't understand electrical terms. You can get harmed while following the process since electricity is something which we should not play with. I hope you find this answer informative.

Read more:

The fan motor's speed is regulated or controlled by regulators, as the name suggests. One of the most frequent appliances in an Indian home is a ceiling fan. Ceiling fans widely used all over the world, especially in India, can be found in nearly every room. Different ceiling fans come with different types of regulators. If you want to know how to connect fan regulator in home switchboard, go through these steps.

Here are the steps to join the fan regulator connection in switchboard:

a) You will need DP MCB (Double Pole), switchboard, switch, regulator and a fan.

b) One end of MCB is a phase circuit breaker and the second is neutral.

c) Connect the neutral end to the ceiling fan directly and the phase circuit breaker to the switch in the switchboard.

d) Connect the switch outgoing to the regulator and the regulator to the ceiling fan.

e) When you turn on the switch, the fan will start and the dimmer will regulate the fan speed as per your wish.

f) This process will guide you on how to connect regulator of fan in home switchboard.

There are 4 types of fan regulators:

It comes in a box type regulator that can be found in homes. It has a wire wrapped resistor with different contact points that correspond to different resistance values as the speed locations. The voltage provided to the fan is reduced by the addition of resistance. It’s one of the finest fan regulator connections in home switchboards.

An inductive regulator is a device that changes the inductive coupling between a primary and a secondary or driven winding to give variable output voltage. The inductive regulator's rotor remains motionless while the required electrical power transfer rate is established.

A capacitor regulates the voltage across the fan, and the speed of the fan is controlled by the voltage which is present across the fan. Capacitive regulators are considered to be more energy-efficient than electronic regulators because they have good control of speed, operate quietly, and are more reliable. 

Dimmer switches are phase angle-controlled regulators that use active semiconductor transistors. The voltage across the semiconductor device is used to change the voltage across the fan, and the speed is eventually modified continually.

This guide clears your queries regarding how to connect fan regulator in home switchboard.