How to Remove Fevicol Stains from Tiles?

Recently, I noticed some Fevicol stains on my floor tiles. The stains had become dry and were making the tiles look dirty. Last weekend, I decided to clean them. Before starting, I checked a few cleaning steps on YouTube and then tried a simple method. I am sharing the process so you can also understand how to remove Fevicol stains from tiles.

How to Remove Fevicol Stains From Tiles?

1. First, wipe the tile around the Fevicol stain with a dry, soft cloth. This removes dust and helps you see the stain clearly.

2. Next, use a plastic scraper to gently remove the dried Fevicol from the tile. Move the scraper slowly and carefully. Avoid using a sharp metal object because it may scratch the tile surface.

3. After removing the thick layer of glue, dip a soft cloth in warm water. Place the wet cloth over the remaining Fevicol for a few minutes. The warm water helps soften the glue and makes it easier to remove.

4. Then, gently rub the stained area with the same cloth. Don't rub too hard, as the glue may spread onto the tile. 

5. If some Fevicol is still left, mix a small amount of mild dishwashing liquid with warm water. Dip the cloth into this mixture and gently clean the area again.

6. Finally, wipe the tile with a clean, damp cloth to remove the soap and any remaining glue. Use a dry, soft cloth to wipe the tile and remove the moisture.

Before using any strong cleaning product, test it on a small hidden area first. This will help you check whether the cleaner is safe for your tile.

Here is how to clean fevicol stains from tiles using baking soda paste:

• Start by making the paste. Combine baking soda and a tiny amount of water to create a thick paste.

• Now, apply the paste evenly to the Fevicol stain and allow it to settle for 10 to 20 minutes.

• After that, you can clean lightly. Using a soft brush or sponge, gently clean the area in circular strokes.

• Break down residue. Baking soda is a mild abrasive that helps lift dried glue without damaging your tiles.

• Rinse well. To get rid of the paste and loose adhesive, wipe the area with a moist towel.

• If necessary, repeat. For thorough removal, tough stains might require a second application.

• Finally, for a flawless finish, you can use a fresh cloth to dry the tile surface.

Hope you found this method helpful.

Here is how to remove fevicol stains from tiles using a vinegar solution:

1. Prepare the solution:

   Combine equal parts white vinegar and warm water in a basin or spray bottle.

2. Soften the stain:

   To remove the adhesive, apply the solution immediately to the Fevicol stain and leave it for ten to fifteen minutes.

3. Scrub gently:

   Now, use a soft cloth, sponge, or an old toothbrush to clean the area without causing damage to the tile surface.

4. Repeat if necessary:

   Apply the vinegar solution again and give the stains additional time to soak.

5. Wipe clean:

   You can now use a moist cloth to wipe the area after the glue has loosened to get rid of residue.

6. Finally, dry the surface:

   Use a fresh, dry cloth to prevent water stains or marks.

Vinegar works best on fresh or partially dried Fevicol stains and is compatible with most tile varieties. So, you can try this DIY hack. Hope you get an idea of how to remove fevicol stains from floor tiles.

Hire NoBroker Cleaning Expert to Clean and Restore Original Shine of Your Tiles at Low Cost.