Which type of wiring is suitable for multi storey building?

The tree wiring method is suitable for multi-storey buildings. This method uses a single main power line and branches off many lines from it, like a tree structure.

1. First, the electric supply enters the building from the source. 

2. Then, a rising main is installed in a vertical direction. This main line safely and continuously carries electricity to all floors of the building.

3. Next, each floor connects to the rising main. A sub-main board is provided on every floor. This board controls and distributes the power supply of that floor properly.

4. After that, branch lines are connected from the sub-main board. These lines supply electricity to rooms, shops, and offices in an organized way. Each branch line works as a separate circuit for better control.

5. This method gives a clear and simple distribution of power in the building. Each section receives electricity properly and without confusion.

6. It allows easy fault checking in the system. Faults can be located and repaired quickly without disturbing other sections of the building.

7. This method gives flexibility in wiring design. New connections can be added easily when required.

8. The wiring arrangement stays neat, safe, and easy to understand during maintenance work.

9. It also provides equal and proper power supply to all floors and sections.

So, the tree wiring method is suitable for multi-storey buildings. It uses one main line with branch lines to supply power. This method gives a simple design, easy control, and proper power distribution to all floors and sections. I hope you know which type of wiring is suitable for multi storey building.

Hire NoBroker Professional Electrician for Proper Wiring in Multi-Storey Building at Best Price.

I am really glad that a number of laws, norms, and restrictions have helped to standardise electrical wiring systems. In compliance with electrical rules and standards, electrical wiring should be done safely and properly. But you must know which type of wiring is suitable for multi storey building.

Which is the best wiring of multi storey building?

1) Tree System Wiring

The L and N wires from the cable are linked to two terminals in the main switchboard using the tree system. A fuse is used to power home electricity. In this circuit, the lamps and the plug end for the fan or table light are all linked in series across L and N. They are each controlled by a different switch on the livewire end. The fuse is attached to two or more three-pin power outlets. They can be used to power appliances like toasters, hot surfaces, and irons. The third wire is the ground wire, which is attached to the appliance's metal frame, which is grounded. The approach is known as the "tree system" because it branches out from the main switchboard to various parts of the house.

There are some drawbacks to the tree system. Two or more devices need to be checked if a fuse falls off. The distributing board is crowded with an excessive amount of wires of various ratings coming from various parts of the home. It's possible that there won't be room in the main switchboard for more wires if more points are needed in the future. The ring system is quickly taking the place of this arrangement.

2) The Ring System Wiring

The three wires L, N, and E work together to generate three distinct rings that encircle the house. The key benefit of the ring system is that every equipment is controlled by a separate fuse. The supplies can be accessed at any suitable area inside the home. You need to check that particular appliance if the fuse blows off. Less wire is needed to set up and operate this system. It should be mentioned that because bulbs have high resistance, the current is little. For lighting applications, fuse and connecting wires are narrower than for heating systems. A heating appliance's low resistance results in a relatively large current demand.

You must have understood which type of wiring is suitable for multi storey building.