How to Seal Marble Tile?

Hey,

NoBroker Home Renovation Service

Get flooring and tile work done by experts at NoBroker Renovation service, offering durable and stylish solutions

End to End Renovation Solutions for Your Home

6-Months Service Warranty

Get Free Quote

Marble is a naturally occurring stone that is rather porous and readily absorbs moisture, making it susceptible to staining. But sealing marble when you install it and maintaining it by sealing it every year or two after that is a pretty simple way to preserve it from stains and moisture incursion. The amount of traffic your marble floor receives will determine how often you need to seal it. Hence, It is imperative to know, how to seal marble tile to protect your marble floor.

Does marble tile need to be sealed?

After installation, the marble tile needs to be coated using a neutral pH breathable sealant. Regular reapplication of the sealer is required; it is advised to do so every 12 months or so.

Use a pH-neutral cleaner designed for marble to give your floor a thorough cleaning before sealing marble floor tile. The use of acid-containing cleansers, such as vinegar, should be avoided because they can etch the stone. Allow the floor to fully dry.

Is sealing polished marble tile necessary or not?

Since polished marble has a very low likelihood of absorbing water, discoloration is far less likely, so sealing is not actually necessary. Additionally, if the marble is not absorbent, the sealer won't work because it won't be absorbed by the marble.

• To make sure the marble sealer won't stain the stone, test a small bit of it in a hidden location. Compare the test area's sealer's look to the other tiles after letting it completely dry. The sealed surface should only be slightly glossier than the surrounding surfaces. Try a different kind of sealer if the sealer produces stark colour changes.

• Utilising a foam brush or soft cloth dipped in sealer, apply the sealer to each tile individually. The objective is to produce a very thin coating that vanishes in a short period of time. Avoid letting the sealant pool. If bubbles do appear, remove them with the brush's front edge.

• Apply the sealer according to the instructions on the packaging; some recommend using a foam brush, while others advise using a cloth. Some sealants even need to be sprayed over the surface.

• As you finish each tiny tile section, brush the marble sealant onto the grout joints. Run the thin edge of the foam brush along each grout line after briefly dipping it in the marble sealant. Wipe up any extra with the brush's broad edge. Since the grout joints are particularly prone to stains, it is crucial that they receive a thorough coating.

• Observe the sealer's total drying time, which is typically two to four hours.

• Apply the sealant to the marble and grout joints once more when it has completely dried. After a few hours, the floor is ready for use, but you shouldn't start washing it normally again until the sealer has fully dried, which takes 48 to 72 hours. Until the sealer has fully dried, you should keep any potentially staining substances (stain agents) away from the area.

I would like to conclude here about how to seal marble tile. I hope this helps :)

Read More: