How to clean bathroom tiles with harpic ?

Harpic has become a stable bathroom cleaner in all homes, and it has been like that for over a few decades. I have been cleaning my own bathroom for a few years now, and I think I am more than qualified to tell you how to clean bathroom floor tiles with Harpic. I have added the steps below, and you can check them out. 

NoBroker Home Cleaning Service

Refresh your bathroom with machine scrubbing of floor & stain removal from wall, tiles and fixtures.

Best Professional Cleaning Service

Starting at Rs. 449

Book Now

How to Clean Bathroom Tiles with Harpic Bathroom Cleaner?

Here are the steps that I followed to clean my bathroom tile with Harpic. 

• Take Precautionary Measures: I suggest that you wear gloves and bathroom slippers to avoid direct contact with Harpic as it is a bit acidic in nature.

• Dilute the Cleaner: Take around 1 to 1.5 caps of Harpic in a bucket of water and mix it properly. This is done to protect the tiles from getting damaged while cleaning.

• Clean the Tiles: Use a brush to scrub the stains off the floor. In case of tough stains, let it sit for an hour. 

• Rinse Thoroughly: Wash the tiles thoroughly with water to remove any leftover cleaner.

And that’s how I cleaned my bathroom tiles with Harpic. I hope this helps. 

You know bathroom cleaning requires special attention because it is where the majority of bacteria and germs are found. Hence, I am using Red Harpic as it is a high-quality bathroom cleaner. Before using it, I researched Red Harpic uses online and found that it can refresh the bathroom, destroy 99.9% of bacteria, and remove stubborn stains. Let’s see how I use this Red Harpic to clean my bathroom tiles.

How to Use Harpic Bathroom Cleaner?

I used to follow the below methods for effectively cleaning my bathroom using red Harpic cleaner:

• I began by vacuuming or sweeping the tile floor in my bathroom and wiping away any loose dirt or debris with a wet towel.

• Next, I follow the directions on the package to dilute the red Harpic cleaner with water in a bucket.

• I use a mop to uniformly spread the already-prepared solution to my bathroom tiles.

• After that, I normally leave the solution to rest on the tiles for a few minutes.

• After that, I carefully circularly scrub the tiles using a scrub brush.

• I next completely rinse my tiles with fresh water to get rid of any last bits of cleanser residue.

• Finally, I wipe and dry the tiles with a fresh towel to get a glossy finish.

Furthermore, since the cleaner can release powerful fumes, you must maintain adequate ventilation throughout the cleaning procedure. If you don't have time, then you must hire a professional bathroom cleaner.

I hope you understand how to use Red Harpic bathroom cleaner.

A room in the house that gets considerably dirty is the bathroom. If you have white-colored tiles in your house, you must have noticed the thin layer of dirt on the bathroom floor. I will share with you how to clean bathroom tiles with Harpic and enable clean living for you.

NoBroker Home Cleaning Service

Refresh your bathroom with machine scrubbing of floor & stain removal from wall, tiles and fixtures.

Best Professional Cleaning Service

Starting at Rs. 449

Book Now

Before, we begin with the cleaning process. Let me tell you about Harpic. 

It is one of the most famous disinfectants and cleaning liquids that claims to remove stains. To give your bathroom floor a freshening effect. Read the process below. 

•  Take 1.5 cup full of Harpic Bathroom Cleaner and add it to half a bucket of water (4 litres). 

•  Now, you have a cleaning solution. 

•  Simply, sweep and mop the floor like usual.

•  Scrub gently with a sponge

•  Rinse the floor once you are done.

You can apply the cleaner on the bathroom floor, tiles, and sink area. I would recommend you pour undiluted Harpic on tough stains for best results.