How to Use Sheenlac Wood Polish?

Before you apply Sheenlac wood polish, ensure the wood is dry, clean, and smoothed out using 150–220 grit paper. Here is a step-by-step procedure for how to use Sheenlac wood polish:

• Clean out the wooden surface:

  To get rid of dust and grime, use a dry or slightly moist cloth to wipe the wooden surface.

• Light sanding (if required):

  If the surface is rough, use fine-grit sandpaper to gently sand it. After that, wipe off the dust.

• Mix the polish:

  Gently stir the Sheenlac polish after opening it. Avoid shaking the container.

• Put on the initial coat:

  You must now apply a thin, uniform layer along the wood grain using a clean brush.

• Allow it to dry:

  As directed on the package, let the polish dry completely.

• Scrub the surface:

  To improve gloss, gently wipe the surface with a soft cloth once it has dried.

• Put on a second coat (optional):

  Apply a second thin layer and allow it to completely dry to get more gloss on your wooden surface.

• Allow adequate drying time:

  Until the polish is completely dry, don't use the furniture.

Tips on How to Apply Sheenlac Wood Polish for Best Results

• You must always work in an area with adequate ventilation.

• For a smoother finish, do apply thin coats.

• When the surface is dry, don't touch it.

• If necessary, reapply every two to three months.

Sheenlac wood polish provides a rich, glossy sheen while protecting hardwood surfaces. Proper ventilation during application leads to faster drying and a smoother finish on the wooden surface. Hope this helps you.

Our guest room had a wooden table which looked dull and worn out. There were visible scuffs and scratches all over it. So, to give it a renewed look, I knew I had to use sheenlac wood polish. I didn’t know the exact steps so after researching a bit, I came across a few websites that explained how to use sheenlac wood polish. I am sharing the DIY steps that I followed below for your reference.

Sheenlac Wood Polish How to Use?

If your wooden furniture has faded stains, you might consider using sheenlac wood stainer to add colour. You can follow the below instructions to understand how to use sheenlac wood stainer.

Preparation

Before you apply the polish, make sure you clean the surface. I used a damp cloth to wipe off the dirt. Then, I applied one coat of Sheenlac NC sanding sealer to ensure the surface is smooth enough for the paint.

Apply the Polish

Use a brush or an applicator pad to apply the Sheenlac wood polish on the surface. I applied a thin coat of polish in the direction of the wood grain. This helps in creating a flat, even surface. Once you’re done, allow some time to dry before applying additional coats. 

Buffing

This is optional but to ensure you have a glossy and smooth finish, it’s important to buff the surface. I used a clean, dry cloth to buff the table. Do this after the polish has completely dried. 

I hope this helps you understand how to apply sheenlac wood polish.