How to Use Birla Wall Care Putty?

Here is how to use Birla White putty:

1. First, prepare the wall surface. Remove dust, loose paint, and dirt using sandpaper or a wire brush. Make sure the wall is clean, dry, and free from oil or grease. A clean surface helps the putty stick well.

2. Next, mix the putty. 

3. Slowly add Birla White WallCare Putty to clean water in the correct ratio. 

4. Mix it well for 10 to 15 minutes until you get a smooth paste without lumps. 

5. Prepare only the amount you can use within 3 to 3.5 hours.

6. After mixing, pre-wet the wall with clean water. Do not leave water running. A damp surface improves bonding and smooth spreading.

7. Now apply the first coat. Use a putty blade and move it upward. Apply a thin and even layer. Let this coat dry for at least 3 hours.

8. Once dry, lightly smooth the surface using a wet sponge or a putty blade. This removes uneven spots.

9. Apply the second coat if needed. Keep the layer thin and even. Let the wall dry completely, preferably overnight.

10. Finally, lightly sand the surface with waterproof emery paper. This gives a smooth white finish and prepares the wall for painting.

Always follow the recommended drying time between coats, and avoid applying thick layers of putty. Thin coats dry evenly, prevent cracks, and give a smooth, long-lasting finish. Hope this helps you.

To use Birla White Putty, first clean the wall properly. Remove dust, loose paint, and dirt. Keep the surface dry and free from oil. In addition to this, follow these steps:

1. Mix Birla White WallCare Putty with clean water in the correct ratio to make a smooth paste. 

2. Use the mix within three hours. Lightly wet the wall before application. 

3. Apply a thin and even first coat using a putty knife and let it dry fully. 

4. Smooth the surface gently. Apply a second thin coat if needed and allow it to dry. 

5. Finally, sand lightly to get a smooth finish.

Hire NoBroker Expert Painters for High-Quality Wall Putty Application.

Hey Vaani, I saw you asking about the Birla wall putty application procedure and can tell you the same. Firstly, you must make a paste by adding about 35 per cent water to the putty. For the entire process, I am sharing a stepwise guide to make things easy to understand.

How To Use Birla Wall Putty?

Below, you can find the complete steps:

1. Add water to the putty. You must add water to the putty and not the opposite to create the paste. 

2. Mix for a minimum of 10 to 15 minutes till you make an even paste. Only make enough paste, that can be used completely within 2 to 3 hours of mixing the putty with water.

3. Pre-wet the surface before applying the putty. Then, apply the first coat of putty on a moist surface from bottom to top. 

4. Once the first coat is applied and gets dry, use a wet sponge and gently rub the surface. 

5. Wait for three hours at least and then apply the second coat of putty. 

6. Once the coat dries, you can remove any markings; 

Birla White Wallcare Putty Can Be Used For?

Here are the uses of Birla white putty.

1. It is used to improve the bonding and coverage and get a smooth finish.

2. It helps in preventing the peeling of plaster and gives a glossy finish.

3. It is used to cover uneven surfaces of the walls.

4. It is a better alternative to POP as it does not absorb any moisture.

This is all from my side. I hope you now know how to use Birla White putty. 

How to Use Birla Wall Putty?

• Wall preparation

• Mixing

• Application

• Second coat

• Dry it off