Recently, the cooling performance of my Whirlpool air conditioner was quite low. So I tried to reset it. And guess what, after resetting, the AC started working well again. It's actually a simple process. Just grab your AC remote and press a reset button. If you can’t find the Reset button, I can walk you through the other method to know how to reset Whirlpool AC remote.
NoBroker AC Services
Get your AC running like new with expert repairs.
Hire Expert AC Technician
Starting at Rs. 289
How to Reset Whirlpool Air Conditioner Remote?
Here are two methods to reset the air conditioner of Whirlpool.
First method
First, turn off your AC at the circuit breaker to prevent it from cycling.
Next, press the reset button on your AC and hold it for 3 to 5 seconds before releasing it.
Then, turn the power back on at the circuit breaker. Ensure your AC is set to ‘on’ and the thermostat to ‘cool.’
Finally, listen for the AC to start up and check if cool air is blowing by holding your hand over the vent.
Second Method
To reset the AC,
Turn off your thermostat.
Cut power to the AC unit.
Restore power after 5 minutes.
Then turn the thermostat back on after 1 minute.
I hope now you know to reset your Whirlpool AC.
Hire AC Technician from NoBroker and Get Your Whirlpool Air Conditioner Repaired at Affordable Rate
Read More:
Your Feedback Matters! How was this Answer?
Hire Expert AC Technician
✔
Trained Professionals✔
Assured Warranty✔
Free Reschedule
AC Repair
Book Now
AC Gas Recharge
Book Now
AC Servicing
Book Now
AC Installation & Uninstallation
Book Now
How to Reset Whirlpool Air Conditioner?
Samantha34
463 Views
1
2 months
2025-03-24T20:48:51+00:00 2025-03-29T20:16:32+00:00Comment
Share