How to Make Bubble Water Wall?

Hi Friend,

NoBroker Home Painting Service

Get premium quality painting for your home at affordable rates. Prices Starting Rs. 3500 only.

Hire Professional Painters

1-Yr Service Warranty

Check Painting Prices

Making a bubble design on wall is a technique that involves designing a glass or other clear material to exhibit bubbles. It is not a straightforward task because it necessitates your knowledge of several technological gears.

Custom water bubble walls are extremely adaptable and can be utilised in almost any industry. Free-standing, large fountains can be used as a room or wall dividers. Small, wall-mounted bubble walls can be used in place of boring, generic paintings. Medical and dental office waiting rooms, restaurants, spas, bars, and clubs all visually benefits from bubble walls. They can also be used as part of a man cave, entertainment area, or in-home bar in the home.

I have recently learned how to make bubble water wall. I would like to share my experience with the same.

• Acrylic tank:

1. Prepare the four acrylic pieces, two big panels and two 1′′ broad strips the same length as the larger panels

2. Layout the bottom panel, then use the universal transparent silicone to design the panels, 

3. Then use the silicone to attach the two strips to each side. 

4. To make holes in the tubing, I used a thumbtack and then attached the tubing to the acrylic panel

5. This is a pretty simple approach to make a bubble wall, but it cannot be cleaned this way. So, if the water turns milky due to ordinary water, time, or not using the BCB water treatment fluid, you'll have to start over

Now, after the acrylic tank required for the water bubble wall panel diy, let us move on,

• Aerator

with pressure control that can be adjusted. This contained components like tubing and a check valve

• Frame

1. Aluminium was used as the frame since it is lightweight and slightly reflective (perfect for my future sensory room designs!). 

2. Also, wood would definitely be ideal in this situation. I was set on hanging it on the wall rather than on a stand, so aluminium made sense at the time. 

You can mount it on the wall with a quality Aluminium Frame or Aluminium Sheeting. This will be done by local metal makers as well!

1. Using adhesive wire clips, I wrapped aquarium tubing around the metal frame (on the inside) and linked it to the bubble wand extension I made from small acrylic tubing. The aquarium motor is directly connected to this longer tubing.

• LED Lighting

When compared to traditional bulbs, LED lighting provides great performance, low voltage, and exceptional efficiency. This implies virtually little heat generation, low operating costs, and excellent light output for your design!

1. I went for lighting that changes colour on command via the accompanying wireless remote control unit, but that rotates through the colours on a regular basis

2. I attached the power unit to the underside of the aluminium frame with Velcro adhesive. I also used three J-Channels to assist cover the LED strips and direct the light within the acrylic tank

3. I also used a rubber sheet to offer a layer of protection between the aluminium frame and the acrylic tank. Then, on top of that, bolted the metal piece that would be attached to the wall to the rear. I drilled these holes with a spacing of 16 inches apart

• Water Filling, Operation, and Maintenance

1. Make sure the air pump is turned on!!!

Before and throughout the water filling procedure, the air pump should be turned on

1. Check the LED light’s power supply for functionality

2. Fill the device halfway with water. Check for leaks after filling to about 1/4 full with distilled water

3. To avoid accumulation, use distilled water. Because some evaporation will occur over time, keep a supply of distilled water on hand

Enjoy your new bubble design on wall's calming and memorising effects!

Read More: