How to install shower panel tower?

2 months ago, I planned to upgrade my bathroom slightly and add a bit of luxury. I heard a lot about the Shower Panel Tower from my colleagues. Hence I went for it and a bathroom towel hanger to give it that clean, organised look. I called a plumber to help install them since I didn’t want to mess anything up. Here’s how to install shower panel tower.

Get Free Estimate

How to Install Shower Tower Panel?

Watching him work was pretty interesting; it looked simple, but he had a few tricks to make sure everything was secure and neatly done. Here is the process he followed::

• He carefully measured the location where I wanted the towel hanger to be installed. To ensure it was level, he marked the spots.

• He then used anchors to secure the hanger in place after drilling holes in the wall.

• In order to prevent any water mess, he began the Shower Panel Tower installation by making sure the main water valves were shut.

• He marked the location of the panel, making sure it matched the height of the plumbing that was already there.

• Then, he attached brackets to support the panel securely and connected the water lines carefully. 

• Once everything was fixed, he tested it to make sure the water pressure was even across the panel. The shower tower worked perfectly, with no leaks or drips.

I hope you get an idea of how to install a shower tower.

Also Read: 

You choosing from the many available options in the market as a newcomer trying to upgrade your bathroom to give it a unique appeal may be both complicated and irritating. Relax, you're about to learn a lot of information about how to install shower panel system.

How to install shower tower panel?

A few basic tools required to install a shower panel are most likely already in your toolbox. Assuring you have everything you need will help you complete the installation faster. In most circumstances, you'll need the items like an electric drill, mounting hardware, waterproof sealant, cleaning cloth, level, etc.

Steps on how to install shower panel tower:

1) If you're replacing a shower panel in a working shower, make sure the work area is completely dry. For safety and to protect the flooring surface, put a drop cloth over the workplace.

2) Hold the shower panel in place and note the location of the installation on the wall. Make sure your marks are in the correct spot. These markers will be used to drill holes for your necessary hardware.

3) Drill the mounting hardware's screw holes. Make sure you're using the right bit for the job.

4) Install the mounting bracket on the wall. Make sure you're using the right hardware for your wall type. You may need to purchase additional hardware if your shower panel kit does not include the appropriate hardware.

5) If required, connect the hand shower hose to the outlet on the shower panel. To secure the connection, tighten the bolts on both sides.

6) If your setup comes with a shower arm, connect it. The shower arm on most shower panels can be adjusted in place with your hand. To maintain the finish of the shower arm, tighten with an adjustable wrench and a cotton cloth.

7) Connect the shower panel's water tubes to the main water supply. Check for leaks in the water tubes by turning on the water.

8) Using the mounting hardware, secure your shower panel to the wall. Make sure the panel is levelled before hanging it.

9) Make that the hot and cold water supply is both operational. You should do this right now because you're preparing to install the shower panel.

10) Seal the top and sides of the shower panel with silicone sealant. The bottom of the panel should not be sealed. If water does get inside the machine, this port will allow it to leave. Using a wet clean cloth, wipe away any excess silicone sealant.

Now you know how to install shower panel system.