How to install a heat pump for swimming pool?

Recently, I planned to install a heat pump in my swimming pool to maintain a comfortable water temperature throughout the year. However, I was unsure how to install a heat pump for pool. So, I researched and found that, though the process is simple, you must hire a professional plumber to install it. I have shared the process I came across with you below.

Get Free Estimate

How to Install Heat Pump for Pool Easily?

Although a swimming pool is a brilliant investment, it is difficult to keep the water warm all year round. I found that electric resistance and conventional gas heaters offer rapid heating, but they are very expensive. 

Here are the steps you can follow to install a heat pump for your swimming pool.

1. Depending on your pool’s size, climate, and preferred temperature, pick the proper heat pump.

2. Now, pick a suitable spot that is level, has good ventilation, and is near plumbing and electrical outlets.

3. Remove the dust from that area.

4. Before installation, review local building standards and regulations.

5. Turn off your pool pump’s electricity at the circuit breaker. 

6. Using the proper fittings and sealants, attach the heat pump’s suction and discharge lines to the pool’s plumbing system.

7. As directed by the manufacturer, connect the heat pump to the electrical supply after making plumbing connections.

8. Finally, you must turn on your heat pump, then look for leaks.

I am planning to hire a plumber for this task.

Hey,

Installing a heat pump for a swimming pool is a fairly complicated task and should be completed by a professional electrician or experienced pool owner. I suggest you follow the manufacturer’s recommendation to ensure you don’t invalidate the warranty stays validated and to ensure your heat pump works properly. Here are some great swimming pool heat pump installation tips:

• A heat pump requires adequate air circulation and works perfectly outside with plenty of clearance surrounding the unit without any obstructions. Details such as the ideal location of the unit, proper clearance, etc. are mentioned in the owner’s manual.

• The heater should be installed as close to the filter as possible and approx. 25 feet away from the pool.

• An "ideal" installation has about 24-inch of clearance around the unit without any obstruction above. However, there can be some exceptions, so consult an electrician first.

• After getting the unit wired by an electrician, you should read your owner's manual to know more about the controls. Make sure every valve is open to allow water to get to the pool heat pump.

• Please ensure that the air being exhausted from the top is cooler than the ambient air when the unit is running in the heating mode. If the heat pump is still running even after turning the water pump off, then turn your heater off and call the electrician.

• I hope you find these tips on “how to install a heat pump for swimming pool” helpful.

I strongly believe that you should take the help of a professional to get the swimming pool heating pump installed.

I hope you liked my swimming pool heat pump installation tips.