How to fit a countertop basin sink?

Recently, my old countertop basin sink started to leak. So, I decided to install a new basin sink in my kitchen and hired a plumber. He took accurate measurements, then turned off the water supply and removed the old sink. I carefully watched the process to learn how to fit a countertop basin sink, which I have shared here for your reference.

How to Fit a Counter Top Basin?

1. The plumber first measured the height for the new basin, usually between 29 to 36 inches from the floor. He checked the space on the countertop and made sure there was enough room for the tap and basin.

2. He turned off the water valves under the sink and opened the taps to drain leftover water. 

3. Then, he carefully disconnected the water pipes and the drain pipe. 

4. After that, he unscrewed the old sink and removed it by loosening the seal around it.

5. Before placing the new basin, he fixed the new tap in the right position, making sure the water spot would fall correctly into the basin.

6. He put the basin on the countertop and sealed the edges with silicone to stop any water leaks. Sometimes, a rubber gasket is used instead of sealant.

7. Next, he reattached the drain pipes and water supply lines tightly, using his tools.

8. Applied extra sealant around the basin and drain to prevent leaks, then wiped off the extra.

9. After waiting for the seal to dry, he turned on the water and checked carefully for any leaks from the taps or pipes.

I hope this helps!

Hire Expert Plumber for Basin Sink Installation Work at Affordable Rate through NoBroker

Hi there,

A countertop basin sink is always connected to the wall. The countertop basin sink has become popular since you can easily use these basins in the bathroom. It is both helpful and increases the beauty of the bathroom. Are you looking for any hack on wash basin fittings? Well, you have come to the right place. I will share a step by step guide on how to fit a countertop basin sink.

How to fit a countertop basin sink?

For wash basin installation, you will need some products handy. So I will list some items below.

Wash basin fitting items are:

• Measuring tape

• Jigsaw Blade

• Screw

• Caulking

To install a countertop washing basin sink, check out the 6 easy steps below.

1. Firstly measure the area to understand how much space the washbasin will take.

2. Test one, and try to dry-fit the basin to understand if it's going to fit perfectly.

3. Check the area and the wall and mark the area with a pencil. 

4. Make a scribe line using a jigsaw and fit the countertop.

5. If you have cabinets then screw the countertop to the cabinets. 

6. Apply caulking. This is a very important part to protect your new washbasin from mildew. On the other hand, caulking is also used for sealing the joints and helps to prevent leakages.

This is the process of wash basin fittings installation. I hope you like it.

Read more: