How to Change Hot and Cold Taps to a Mixer?

If done correctly, replacing the hot and cold pipes in a mixer tap is an easy do-it-yourself project. It replaces worn-out connectors, enhances water flow, and fixes leaks. Make sure you have plumbing tape, new pipes, and an adjustable wrench before you begin. So how to change hot and cold taps to a mixer? The basic steps involved in this process are as follows;

1. To prevent spills, stop the water flow.

2. To access the pipes, unscrew the faucet body beneath the sink.

3. Detach old pipes. Both hot and cold pipes can be loosened and removed with a wrench.

4. Install new pipes. To stop leaks, firmly attach the new ones, hot to hot and cold to cold.

5. Reinstall and test. Replace the faucet, switch on the water, and make sure the hot and cold flow is working properly.

I hope this helps!

Easily Change Hot and Cold Taps to a Mixer at an Affordable Rate Via Expert Plumbers at NoBroker!

To replace hot and cold tap with mixer, first, turn off the water supply. The current hot and cold taps and their pipes should be loosened and detached using a wrench. To stop leaks when installing the new mixer, make sure the pipes are lined up properly, hot to hot and cold to cold. Tighten all of the connections firmly. After mounting the mixer on the washbasin and connecting the pipes, restart the water supply.

These are the basic steps that must be followed to replace hot and cold taps with a mixer. However, there are a few things that must be considered in this process:

1. Make sure there are no leaks in any connections.

2. If additional sealing is required, use plumber's tape.

3. For safety, if in doubt, seek advice from a trained plumber.

I hope this helps!

Get Expert Plumbing Solutions at NoBroker to Replace Hot and Cold Taps with Mixer

Hi buddy. Like you, I also had two different fixtures in the kitchen sink and want to control both with one knob. So, I called a plumber to help me out with this. The expert said it can be done easily by replacing them with a mixer. He first purchased a mixer tap that fit the existing holes in my sink. I watched the process he followed on how to change hot and cold taps to a mixer. I have shared the detailed process for you below.

How to Convert Hot and Cold Tap to Mixer?

Here is the process the professional plumber I hired followed.

• Using a wrench, he first shut off the water supply to my sink.

• He took off the old hot and cold taps with an open-handed spanner.

• After that, he sealed the hoses and made sure the mixer was waterproof.

• You can now secure the mixer in place by passing hoses through the sinkhole, much like our plumber did.

• Now fasten the mixer with a nut, tightening seal, and stabilising ring.

• Finally, our plumber tightened the provided nuts and reoriented the mixer.

To convert two different taps that supply hot and cold water into a single mixer tap, you must follow the instructions above. Please be aware that some processes may vary somewhat. This is because of the sort of taps you are using or the nature of your installation.

Read more