A malfunctioning ballcock can stop the tank from filling correctly or result in continuous water overflow. You can guarantee appropriate water flow, save waste, and preserve the tank's effectiveness by replacing it. So, how to change a ballcock in a water tank? The first step is to avoid spills, turn off the main water valve.
How to Replace Ballcock in Water Tank?
To remove water below the ballcock level, open a tap.
Remove the input pipe and unscrew the mounting nut holding the ballcock in place.
Reattach the inlet pipe, tighten the mounting nut, and place the new ballcock.
Make sure the water stops at the appropriate level by adjusting the float arm.
Open the main valve, check for leaks, and ensure proper functioning.
Also, remember that regular maintenance can prevent repeated replacements.
Get Your Water Tank Repaired or Replaced Via Expert Plumbing Solutions at NoBroker!
Your Feedback Matters! How was this Answer?
Shifting, House?
✔
Lowest Price Quote✔
Safe Relocation✔
Professional Labour✔
Timely Pickup & Delivery
Intercity Shifting-Upto 25% Off
Check Prices
Intracity Shifting-Upto 25% Off
Check Prices
City Tempo-Upto 50% Off
Book Now
Around a few weeks back, I noticed that the ballcock of my water tank was overflowing. Since I have a bit of knowledge about plumbing, I inspected the issue and learned that the overflow was because the brass nipple in the valve had worn out. I planned to change it on my own and looked up the steps on how to change a ballcock in a water tank.
How to Replace Ballcock in Water Tank?
After learning about the steps, I followed them accordingly to resolve my issue. Here are the steps that you can follow to replace the ballcock in the water tank.
Start by turning off the valve that flows into the tank.
Use water pump pliers to unscrew the end cap and remove it from the valve body.
Next, use the pliers again to squeeze the ends of the split pin together and pull it out.
Following that, wiggle the float arm a bit and push it downwards.
Check if the floats are in good shape or not. If not, replace it.
Slowly remove the washer and slider using a screwdriver.
Replace the slider and put back everything in the way you had taken out.
Finally, turn the water on and check if everything is working.
If not, then hire a professional. I hope this helps.
Hire Expert Plumbers through NoBroker to Change a Ballcock at Low Cost
Read More
How to Change a Ballcock in a Water Tank?
Ajith
83 Views
2
9 months
2025-02-19T10:07:34+00:00 2025-02-19T10:07:34+00:00Comment
Share